Lform Inventor e/o SolidW
ciao people, with versione 19 how is possible to load file direclty from inventor and or solidworks, in the menu load I did'nt found the right format ??
|
Re: Lform Inventor e/o SolidW
Hello Maurizio
if you have bought an installed the right plug-ins. Then you can go 2 "file" "Modules" "Data interfaces" and enable for the session. Or enable them in "Startup" to start the translators for the future. |
Re: Lform Inventor e/o SolidW
Version 19 adds native file loading for Solid Works and Inventor as part of base license.
In Modules Startup, make sure you have Inventor (native import) and SolidWorks (native import) in you startup sequence. I don't think these modules have a check box in the Modules interface. In your File - Load - File Type drop down, you should have both a line for SolidWorks and a line for Inventor, down below IGES, STEP, SAT, and Creo Parametric/Direct, depending on what other importers you have activated. |
Re: Lform Inventor e/o SolidW
If you used customizations from a previous version, then you will not see SolidWorks or Inventor in the drop down list.
If I remember correctly, the all_data.lsp file will cause this issue. Regards Tom |
Re: Lform Inventor e/o SolidW
I think you aware of Version 19 adds native file loading for Solid Works as part of base license.
Unfortunately, it doesn't provide option for accuracy handling for SolidWorks Native load. Typically, we would like to chose the right geo resolution (e.g. 1xE-6mm) for our company. I submitted an PTC enhancement request for voting as URL below. I appreciate your support. https://www.ptcusercommunity.com/ideas/5577 |
All times are GMT -8. The time now is 03:53 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.