#1
|
||||
|
||||
CFdesign For CoCreate OneSpace Modeling
The Fastest Way from CoCreate OneSpace Modeling to Flow & Thermal Solutions
CFdesign® software turns CoCreate OneSpace Modeling into a fully interactive flow bench, thermal test rig, and wind tunnel. Your 3D assemblies become associative, zero-cost prototypes revealing critical engineering information not available from physical tests. Make a design change in CoCreate OneSpace Modeling and see the change immediately in CFdesign. Go from CoCreate OneSpace Modeling to first pass results in minutes; review high fidelity solutions up to 20x faster with the new Accelerant™ Solver. Read more about CFdesign.
__________________
David@CoCreate |
#2
|
|||
|
|||
Re: CFdesign For CoCreate OneSpace Modeling
Hi David,
Long time since we chatted, I hope you're doing well. Regarding Cocreate/CFDesign users, can you direct me to any with electronic enclosure thermal analysis experience? I'm doing a survey of what's out there and I'd like some anecdotal experiences. Thanks, Marc |
#3
|
||||
|
||||
Re: CFdesign For CoCreate OneSpace Modeling
Are you looking for CoCreate case studies or success stories?
__________________
David@CoCreate |
#4
|
|||
|
|||
Re: CFdesign For CoCreate OneSpace Modeling
both would be helpful
|
#5
|
|||
|
|||
Re: CFdesign For CoCreate OneSpace Modeling
David, Marc,
I'm with Blue Ridge Numerics (the company that makes CFdesign), thought I'd jump in to help. Couple public resources available on our web site: http://www.cfdesign.com/Products/cocreate/default.asp http://www.cfdesign.com/customerbriefs/ek.asp Loads of companies use CFdesign with CoCreate but I'm hesitant to post them in a public forum without their consent. I'd be happy to talk more freely offline if you'd like. Hope this helps, Doug |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|