CoCreate User Forum  

Go Back   CoCreate User Forum > Old NewsGroup Archive > Archive Forums > Macro

 
 
Thread Tools Search this Thread Rate Thread Display Modes
  #1  
Old 06-08-1999, 09:06 PM
Darren Litherland
Guest
 
Posts: n/a
Error in goodies: "Circle_end"

While looking around existing HP/CoCreate macros I was surprised (impressed!?) to find that the goodies macro "Circle_end" included the use of copilot-assistance. I have tried to implement copilot in my macros before but failed. The feedback works well but the copilot-aided "catching" doesn't. The macro "Circle_end" apparently works well and creates circles with the radius shown. But if you check the radius it is inaccurate. If like me, you like to be sure of the accuracy of your drawings I would recommend deleting this macro from the goodies menu. And CoCreate - so these things aren't supported - but are they representative? Perhaps CoCreate are unaware of this anomaly and actually believe that it is possible to integrate copilot within macros!
  #2  
Old 01-31-2002, 12:22 AM
Patrick
Guest
 
Posts: n/a
re: Error in goodies:

I have notices this with this macro. To over come it until a fix has been found, I just type in the required radius.
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -8. The time now is 01:35 AM.



Hosted by SureServer    Forums   Modeling FAQ   Macro Site   Vendor/Contractors   Software Resellers   CoCreate   Gallery   Home   Board Members   Regional User Groups  By-Laws  

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.