#1
|
||||
|
||||
defining isometric view angle
Is there a command which sets or defines the isometric angle in the predifined isometric views in OSD ver 12.01?
__________________
Thanks.....Randy Last edited by randyss; 12-07-2005 at 09:45 AM. Reason: add appplicaton applicable to |
#2
|
||||
|
||||
Re: defining isometric view angle
View/Settings/Iso Mode... not sure if this is what you are looking for.
|
#3
|
|||
|
|||
Re: defining isometric view angle
Put an extra command in the sd_avail_cmds.cmd file
("Isometric SPEC1" :title "Isometric SPEC1" :action (ui::uic-set-vp-dir -0.2,-49,1) :image "SolidDesigner/View/isometric_view_-x-yz" ) Henk |
#4
|
||||
|
||||
Re: defining isometric view angle
maybe further clarification is needed. Looking at a standard displayed iso view, you have 2 angles involved, top to bottom and left to right. I would like to be able to control better the top to bottom, which may be adjusting the numbers (1,-1,1) or what ever. Which number controls what? The first=x, second=y, third=z ? Which controls the top to bottom angle?
__________________
Thanks.....Randy |
#5
|
|||
|
|||
Re: defining isometric view angle
Has anyone been able to figure this out? I would like to set up my iso view options to match SWorks. I have used every combination of 1,1,1 but I can't keep the y direction vertical. Thanks.
__________________
Bob Wing CAD Manager |
#6
|
|||
|
|||
Re: defining isometric view angle
Quote:
Mike |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | Search this Thread |
Display Modes | Rate This Thread |
|
|