#1
|
|||
|
|||
part visibility
as a new user I am probably asking a dumb question I have just started using direct modeling and find difficulty in keeping the part i am working on in view in the viewport! Any tool I am using or the part itself only remains visible for the length of time I am using the centre wheel on my mouse.
Can anyone please be of help? |
#2
|
||||
|
||||
Re: part visibility
Paul
Welcome to the group. What kind of computer are you using and what kind of graphics card? What is the operating system? This sounds like a graphics issue. There are several ways to resolve this, but first the above information is needed.
__________________
Tom Kirkman Creo Elements/Direct 20.1 Dell Precision 3581 https://www.o-i.com |
#3
|
|||
|
|||
Re: part visibility
Hi Tom,
I am using a Dell inspiron 1525. I use proengineer wildfire 5/creo and Solidworks on it with no problems at all, so I do not think it is anything to do with the computer set up or graphics card. I am finding it very difficult to get hold of a user friendly manual for this software , so if you where online I could access one I would be very grateful. Best wishes Paul |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|