Dual Monitors

[donniedrake]

Has anyone set up OSD in a dual monitor environment? If so has anyone found a way to have annotation and modeling on separate screens at the same time?

Donnie

[Yoyovento]

Have you solved it ?
I'm looking for exactly same things

[BMaverick]

Nope, so far I have not found a way to do this since release 2005 to 2007.

It is nice to have a widescreen 25-in flat LCD monitor with CoCreate/Creo. Got two of these as Dell monitors.

On another topic, Solidworks can run on this same workstation with the wide dual monitors. I just S-T-R-E-C-H out the SW window from one monitor en to the other monitor end. That's almost 48-inches of total viewing. Solidworks allows you to show components, assemblies and the drawing in the workspace (three indside windows in the workspace). Form there you update one, then click the next indside window for either the assembly or drawing and hit update. That is so SWEET. My productivity in SW is so much faster this way. If PTC makes Creo Direct anything like this, the user base would grow faster. Seriously.

So, at this time, Modeling or Annotation has to be toggled and switched between the two.